Autosport Labs

Hi, My MJLJ v3 instalation have now been running flawless for I guess around 6years. But lately I have noted that I really don't have the power as I used to have and the throttle control is horrible at low RPM. :( I have spend the last couple of months trying to get my mac to connect to the MJLJ, bu...

I have now been running flawlessly with the megejolt for 5 years on my 1968 Lotus Super Seven. But I'm starting to experiece some problems. When hot and accelerating hard, the ignition cuts completely for a few (2-5) seconds, and then continues normally after that. The hotter the worse. Dosent sound...

I'll try to kill the Zener.

also I found this one http://www.autosportlabs.org/viewtopic. ... r&start=30 looks very much like my scenario and suggests to wire the rev counter directly to the PIP signal.

/jano

I have a SMITH RVC rev counter that I'm trying to get working with megajolt. I have built the suggested circut with the zeners and even purchased the prebuild thingy from triggerwheels, but I can't get it to work. When the engine is at idle, the rev counter shows about 1500 rpm, but when increesing ...

Balance is important, you can certainly feel the missing tooth when the trigger wheel is spinning 6000+ rpm My trigger wheels is bolted on the pully with a single center bolt. I have balanced the the trigger wheel with a 4mm screw, the screw also acts as a fixing point going into a grove I have made...

Hi Just recieved my MJLJ today. I was worried about the availability of the Molex connector, but there is no problem with that at all. 1) Brent had included a molex connector :-) 2) The molex connector is the same as the connector (22 pin) you find on a normal PC power supply! All you need to do is ...

Hi

I have a kent 244 cammed Xflow engine with forged pistons.
Any one got a map that they would share with me?

/jano
[email protected]