Search found 47 matches

by 910esprit
Sun Aug 14, 2011 8:11 pm
Forum: Hard Rev Limiter
Topic: Rev limiter cutting in early?
Replies: 7
Views: 13528

Re: Rev limiter cutting in early?

I had a similar problem a few years back.. it turned out to be a broken wire from the crank sensor.. Under hard acceleration as engine moved on mounts the connection broke then as the engine moved the other way it made contact again and everything was fine. occasionally it would die completely and n...
by 910esprit
Thu Sep 02, 2010 8:44 pm
Forum: Powered by Megajolt Gallery
Topic: Lotus Esprit Turbo
Replies: 5
Views: 16036

The starter switch is quite simple, i have an output that goes through a push button swtich (starter Button readily available off e-bay) when this is pressed it energises a relay that shorts across the back of the standard ignition switch. The output is programmed so that it is on and turns off at a...
by 910esprit
Wed Sep 01, 2010 8:14 pm
Forum: Powered by Megajolt Gallery
Topic: Lotus Esprit Turbo
Replies: 5
Views: 16036

No problem at all with the sharing of photos, however if had known you could have used these,:0) http://i245.photobucket.com/albums/gg51/ajaylotus/_JL71388.jpg http://i245.photobucket.com/albums/gg51/ajaylotus/_JL71529.jpg http://i245.photobucket.com/albums/gg51/ajaylotus/_JL71539.jpg They were take...
by 910esprit
Sun Aug 16, 2009 9:32 pm
Forum: Hard Rev Limiter
Topic: Blown Transistor
Replies: 5
Views: 14208

Well its not Q1, i replaced it today and the symptoms are the same... I carried out some tests on the trigger and i get 12volts when the revlimiter is NOT active, this drops to .6volts when the limiter is active. i assume this is correct which shows that the MJLT is performing correctly.... I can on...
by 910esprit
Fri Aug 14, 2009 12:35 pm
Forum: Hard Rev Limiter
Topic: Blown Transistor
Replies: 5
Views: 14208

Sorry for missing your post. If Q1 is damaged it wouldn't forward the signal to the MOSFET, to activate/deactivate the hard limiter. I haven't considered this transistor as a particularly vulnerable component. Now, we do know if the Rev Limiter module does not have a proper ground between it and th...
by 910esprit
Thu Aug 13, 2009 9:17 pm
Forum: Hard Rev Limiter
Topic: Blown Transistor
Replies: 5
Views: 14208

someone must know!!!
by 910esprit
Sun Aug 09, 2009 6:24 pm
Forum: Hard Rev Limiter
Topic: Blown Transistor
Replies: 5
Views: 14208

Blown Transistor

I have just reinstalled my hard cut limiter after diagnosing some problems with the my MJLT V3 (all Sorted Now) and i think i have blown the transistor Q1. I lowered the rev limit to 2000 rpm to test and it all worked fine, i was demonstrating it to a friend and held the engine on the limiter for ab...
by 910esprit
Sun Jun 07, 2009 5:50 pm
Forum: Ignition Map Library
Topic: Lotus esprit turbo (chargecooled)
Replies: 7
Views: 23171

:D oh right,I got carried away there. I'm none the wiser,is 40° normal for idle speed @ 1000rpm? The first bin is the cranking speed advance setting and this engine starts very well with a lot of advance....40degrees is a good setting for cranking.... this engine can be a bit of a pig when hot to s...
by 910esprit
Sun May 17, 2009 7:31 pm
Forum: Ignition Map Library
Topic: Lotus esprit turbo (chargecooled)
Replies: 7
Views: 23171

I can't evaluate/work in kilopascal,only psi. So your 166 KPA equates to 24psi :shock: fookin'ell,that is some boost going through a pair of dells,very impessed. There must be hope for my pinto then :D I am not that brave!!!!! 24psi absolute that is 24-14(atmospheric) which gives a grand total of 1...
by 910esprit
Sun May 17, 2009 6:02 pm
Forum: Ignition Map Library
Topic: Lotus esprit turbo (chargecooled)
Replies: 7
Views: 23171

Lotus esprit turbo (chargecooled)

Engine Mfg: LOTUS Engine Code: 910 Cylinders: 4 Displacement (cc): 2174CC Rev Limit: 6000 TPS or MAP: MAP Boosted or Normally Aspirated: Boosted If Boosted- max Pressure (KPa): 166 controlled by MJLT output. Modifications: 8.0 to 1 compression chrome top pistons Nickosil aluminium liners. Chargecool...
by 910esprit
Sun May 10, 2009 7:43 pm
Forum: Operation
Topic: Switching Maps???
Replies: 8
Views: 7139

Update: on the home straight

Got some time to have alook at the car today, Looks like i am on my way to solving the problem. The VR bracket and Gap are perfect, no movement on the bracket and the gap could not get any smaller with out touching the wheel. A bit confused it decided to unplug the VR sensor and remove it. this is w...
by 910esprit
Wed May 06, 2009 8:36 pm
Forum: Operation
Topic: Switching Maps???
Replies: 8
Views: 7139

Update: Removed rev limiter, still got mis fire..... Rewired so that EDIS can run on its own, All seemed ok but after hard excelleration mise fire on the overrun... then the occasional mise fire under load.... Reconnected MJLT all seemed ok for a while, then after hard excelleration misfire on overr...
by 910esprit
Thu Apr 30, 2009 8:49 pm
Forum: Operation
Topic: Switching Maps???
Replies: 8
Views: 7139

OK replaced coil pack and still get intermittant mis fire. I will have to have a look at the VR sensor on the weekend.... I am pretty sure that i have a problem with the MJLT. I have reverted to origional ignition to test and car runs fine (not as good but there is no misfire..) Anyone upgraded to a...
by 910esprit
Tue Apr 28, 2009 7:30 pm
Forum: Operation
Topic: Switching Maps???
Replies: 8
Views: 7139

Thanks for the reply,
I have now replaced the coil pack but can't test until tomorrow.
If this does not work then i will get the car in the air on the weekend and check the VR sensor and mount.
by 910esprit
Sun Apr 26, 2009 6:24 pm
Forum: Operation
Topic: Switching Maps???
Replies: 8
Views: 7139

Ok further developments, i am now getting a regular misfire, but there does not seem to be a pattern to it. I think it appears more under load but cant be sure. the rev counter drops when the misfire happens, this is driven from the EDIS not the MJLT. I have replaced the EDIS module and still get th...