Hi Brent,
Thanks for your reply and email!
The MJ is functioning well.. A few months ago I tested the car/engine on a dyno. I think the curve is still the same as I loaded the first time (before I installed the rev-limiter) http://www.youtube.com/watch?v=4agiRTFxA4M
Roland
Search found 7 matches
- Fri Sep 20, 2013 9:03 pm
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
- Tue Sep 17, 2013 4:12 pm
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
- Wed May 01, 2013 8:06 pm
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
Hi Brent, The USB - serial adapter is showing up in the device manager. But right now I'm using a computer with a direct serial port. I tested the serial to RJ11 cable adapter. It's working ok! I use the configuration you mentioned and connected through HyperTerminal. When I type, I can see the para...
- Tue Apr 30, 2013 8:32 am
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
Brent please take a look @pictures; http://www.miniprojects.nl/megajolt/bench.jpg http://www.miniprojects.nl/megajolt/screenshot.jpg Tried 3 different laptops, 2 with USB - serial converter, 1 with serial port directly on the computer. Still no connection.. I'm desperate.. Engine is running well, I ...
- Fri Apr 19, 2013 7:11 am
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
Blue-yellow: PIP Blue-red: SAW Green: Rev-counter Brown: GRND Black: 12V (from ignition switch) The coilpack is powered by the same wire as the MJ. For me it's clear this should be connected to the Coilpack Power connection on the Molex connector when the REV limiter is installed. I'll do that if yo...
- Tue Apr 16, 2013 7:05 pm
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
- Mon Apr 15, 2013 3:09 pm
- Forum: Hard Rev Limiter
- Topic: Connection problems after install hard-REV limit
- Replies: 13
- Views: 19798
Connection problems after install hard-REV limit
MJ V4 (Megajolt /E) I wired up the Rev limiter internally.. Used the Autosportlabs website as guide. Everything was simple and clear.. just connecting the solder pads to each other. Do I have to connect the EDIS coil to "coil power" on to the plug? The engine is still running without this ...