Autosport Labs

Would it be possible for you to share the map that was created, as not many people are coming up with zetec maps

Steve

Just to fill you in on latest developments

Car was run on rollers for first time as part of a group outing for our tiger owners club.

Car ran ok up to 5000rpm then power was down. appears our map was not too good after this so more work needed.

Thanks again for your support,

Steve.

Hi Brent Having now used the new software for a couple of weeks we have found that the blue/purple colours are quite hard to see the figures on a laptop outdoors. Can these be changed to a normal black on white setup or be able to have these changeable from a setup screen. Many Thanks Steve. PS Keep...

Hi Brent

Have reloaded bins etc ok. All is sounding good on tickover.

Will report back later in week as to how car runs.

Thanks again

Steve

Brent

Does that mean the values are in the range of 0-100. as at pressent they go to about 160 from old config.

Steve

Hi Brent

Thanks for quick repley, does that mean the load bins are now 10, 20, 30...90, 100. or am I thinking in the wrong direction.

Steve.

New software looking good. All seems to work OK.

One question about load bins.

After performing the TPS calibration noticed the load bins remain the same. Is this correct?

Steve.

Hi Brent

Yes I am running the version 3 controller firmware.

Steve

Hi Brent

To day I too have seen some strange numbers entered into the table. They were 218 ish. If I then reflesh the table it puts the proper ones in.

Steve.

Hi Brent

Excellent software. It seems all is working well.

Just one possible problem is the TPS display only goes to 75%. I have tried changing the map bins but this appears to make no difference. Is the unit expecting to see 0 to 5 volts?

Steve

Hi Chris

I am in Rugby if thats close by.

Regards,

Steve.

Hi

Would you be able to show us the map you have used.

Many thanks

Steve.

Sorry for long delay replying.

I am using a TPS setup. At present can't upload map but you can down load it from link below.

http://homepage.ntlworld.com/steve_randle/

Click ignition link. This was the standard map I started with.

Also the vr sensor is in the correct place on fly wheel.

Steve

Hi All

I have been running a 2.0L zetec with 45 DCOE's and have used the zetec VR sensor onto fly wheel as standard. It works great and there was no real setup at all. Just the Map.

Steve.

Software works fine and installed ok.

But when running the real time display the figures do not change. You get a first reading but then does not update.

Regards

Steve.