Autosport Labs

Hi everyone,

I've tried to disable the custom race tracks and add sectors manually.

However, the configuration wasn't correctly flashed into the device. And after it I constantly get the following message: http://prntscr.com/j5hrk4. While trying to connect to ANY device.

Do you have any ideas?

This is the tricky thing — when I write the configuration, it is set for 0-3 for sure.

But when I read it back, it is sometimes set to 0-255. I couldn't figure our the real source of difference.

Hello everyone! It seems that this issue started appearing in 1.9.0 and is still present in 1.10.2. I have MAP channel set up in the range 0-3 bar. However, in the analysis screen it is shown like it is set in the range 0-255, https://image.prntscr.com/image/pbl5VcB1ROamgeIsUhAFFQ.png . It makes the...

Awesome, thanks
I guess there is a reason to highlight this point in wiki

Are you asking for standard OBD parameters or custom PID mapping? Can't comment on custom mapping but here are the regular steps: Normally you just go into "Setup" --> "OBD-II" and choose parameters as you like... Pick one parameter, set the logging rate, add another parameter by clicking the (+) s...

Hi guys, I'm sure that this is something obvious, but it seems that I miss it :( Basically, could you please let me know, how can I know, which channels are availiable via standart OBDII and which names should I use for them? I've connected the OBDII cable and tried to adding the most obvious one, R...

Thanks! Will try it next weekend and update you about the results.

Hi everyone! I'm trying to use RaceCapture 2 as a scrutineering system to measure MAP and RPM on the competitiors cars, but sometimes data I get from RC2 logger is quite strange. Last weekend I was acquiring MAP data from turbocharged Subaru BRZ using MPX4250A sensor and noticed a very strange behav...

Also seen this today on 1.3.6 + 2.8.3. BTW, earlier app version (1.2.5) shows scripting page without problems.

+1.

Hi guys! Could anyone explain, what should I do after I submitted the new racetrack and updated the racetracks DB in the PC app? Just press the "write configuration" button?

Does anyone know, is it somehow possible to tell GEMS DA that channel is sampled with different rate?

I don't see a way to change the default setting, and the chart created based on 1KHz sample rate for the channel which was actually logged at 10 Hz looks not very nice: http://prntscr.com/8d7h4z

Hi everyone. Just wander if anyone have calibrated this sensor using a manometer? As the chart given in the documentation (http://prntscr.com/8d6wc1) doesn't allow to enter very accurate numbers.

Have the same problem and actually I wonder, how is it possible that 7th analogue channel is used for the battery if the logging unit have 7 physical analogue inputs and I can map e.g. my temeperature sensor to analogue 7?

H guys,

Wanted to check if there is something new about the in-app analyze in RCP? We are trying to build a scrutineering system around it, and I'm afras that voodoo dancing with perl will not give very good results for our team on this stage.