Search found 4 matches

by weiss enterprises
Mon May 21, 2018 3:20 am
Forum: Hard Rev Limiter
Topic: Hard Rev Limiter Rev B
Replies: 0
Views: 4104

Hard Rev Limiter Rev B

I'm using a Megajolt/e on an Autocraft 4 cyl and it works great. I want to install the hard rev limiter I got years ago, a version labeled Rev B. It's similar to the 1.2.0 except all the components were already soldered in and it has 8 open ports under the label SV1 ( as well as the 4 on the bottom)...
by weiss enterprises
Wed Jun 07, 2017 3:51 am
Forum: Q&A
Topic: no comm to megajolt, hardware issue?
Replies: 1
Views: 3513

Solved

Comm issue due to mistaken TXD signal. Handshaking now achieved
by weiss enterprises
Tue Jun 06, 2017 4:25 am
Forum: Q&A
Topic: no comm to megajolt, hardware issue?
Replies: 1
Views: 3513

no comm to megajolt, hardware issue?

This is an initial installation and I have not been able to successfully communicate with the pre-assembled unit. I have verified serial level signals present at the phone connector on the proper pins using a true serial port computer running the latest GUI release on a digital scope. The cable was ...
by weiss enterprises
Thu Dec 01, 2016 1:22 am
Forum: Q&A
Topic: shielded wiring to MJLJt/e
Replies: 1
Views: 3560

shielded wiring to MJLJt/e

I have the wiring from the MJLJ to a terminal block, as well as the EDIS. The wires from the TPS and the CPS on the engine to the terminal block are shielded. Do I need to have the wires from the MJLJ box for the TPS to the treminal block replaced with shielded wiring too?