Autosport Labs

Hello, I want to run the RPM output(grey wire) from a MSD 6AL to the FREQ 1 input of the RCP. The output from the 6AL is a 12V square wave clean signal for shift lights/other devices. My question is if I connect the output from 6AL to the FREQ1 input of RCP, is there anything else that needs to be w...

Thank you, it has been a while since i opened the software.

I have two thermistor style temp sensors from ASL, 1 has 1/8" threads and the other has 3/8" threads. Can anyone provide the calibration tables for these sensors?

Thank you

Thanks a lot for the information. I get 7.38V empty and 2.47V full. I think placing a resistor in-line to the RCP will step down the voltage to below 5V but I am not sure which one to use. Also, does it matter that the voltage is higher for empty? Can I set-up the RCP to account for this? Thanks aga...

Hello, I would like to measure the fuel level in my fuel cell with the original sender. I have the following set-up: ATL float style 240 Ohm empty - 33 Ohm Full with an ATL fuel gauge mounted in dash. My question is how will I convert resistance into a 0-5V signal? What would the voltage be for the ...