RegisterSearchFAQMemberlistUsergroupsLog in
Search found 10 matches
Author Message
PostForum: Q&A   Posted: Sun Feb 27, 2005 3:28 am   Subject: Corrosion

Brent,
The corrosion was around the solder joints. I guess I didn't wash the board down when I finished soldering.
It is in the passenger compartment.
The car had not been driven. Was just sitting ...
PostForum: Q&A   Posted: Wed Feb 02, 2005 3:22 am   Subject: Corrosion on board

On Nov. 7/04 I reported that I had the car running on MJLJ as shipped. The advance was a little high, but it was running.
I now have my new computer, remapped the controller and everything seems to b ...
PostForum: Operation   Posted: Mon Nov 08, 2004 6:03 pm   Subject: Base Map On Chip?

Thanks Brent,
I didn't think it would be good for my car, but wanted to fire it up and make sure it all worked. (It did, with no load.)
I have to wait for good weather, time off, and my laptop, befo ...
PostForum: Installation   Posted: Mon Nov 08, 2004 3:33 am   Subject: Custom Plug Wires?

Went to a company called Aurora Ignition on Friday. They were very nice and made up the wire set while I waited so I didn't have to make another trip. Black or Red. I got the black and am quite happy, ...
PostForum: Operation   Posted: Mon Nov 08, 2004 1:11 am   Subject: Base Map On Chip?

OK! There is a base map on the chip. I have added myself to the success stories. '66 Datsun.
PostForum: Powered by Megajolt Gallery   Posted: Mon Nov 08, 2004 1:07 am   Subject: '66 Datsun 1600 Convertible

It is a runner. Fired it up a couple of weeks ago with just the Edis and had a steady 10 deg BTDC. Finished up the computer this week and plugged it in. No laptop, so watched the timing change with Br ...
PostForum: Assembly   Posted: Sun Nov 07, 2004 9:14 am   Subject: Trigger Wheels / Vacuum Tubing

Just a little info that may help someone else out......

Trigger Wheels - I have come across 2 36-1 wheels which are bolted onto the balancers:

Mid 90's Taurus V6 - about 6 1/4" OD and 2 1/8" ID. ...
PostForum: Operation   Posted: Sun Nov 07, 2004 8:49 am   Subject: Base Map On Chip?

I am going to fire up tomorrow and was wondering if there is a base map programmed onto the chip already?
My laptop crapped out on me so I'm without the ability to do any mapping on my own till new c ...
PostForum: Assembly   Posted: Sun Jun 20, 2004 5:11 pm   Subject: Cases

Put me in for two cases as well. Thanks
PostForum: Q&A   Posted: Mon Mar 08, 2004 5:44 am   Subject: RPM Limit

Brent,
Helping my brother with his 510 racer. Rev limit for his engine is between 9-10,000 RPM. I have searched the web and come across several references in the 8-9000 rpm for the EDIS unit, as well ...
 
Page 1 of 1
All times are GMT