RegisterSearchFAQMemberlistUsergroupsLog in
Search found 9 matches
Author Message
PostForum: Sensors   Posted: Sat May 07, 2016 11:53 pm   Subject: Tapping existing Tach line

Yeah worked fine. Only issue I have experienced is if you shut off the engine it tends to "stick" at the last running RPM. However once the engine starts again it all works again.
PostForum: RaceCapture/Pro introductions   Posted: Sat May 02, 2015 2:27 pm   Subject: Hi from NorCal LeMons racer

I've seen you guys at the track for most of the races. We should like up next time. Mike
PostForum: RaceCapture App Operation and General Q&A   Posted: Sun Mar 22, 2015 5:19 pm   Subject: Status of native GEMS export in V2?

I hacked the script to work with the latest version of RCP as well. Loads ok and I can do analysis but has anyone had any luck getting GEMS to recognize the lap data. I read the GEMS manual and it see ...
PostForum: RaceCapture App Operation and General Q&A   Posted: Fri Mar 13, 2015 2:00 am   Subject: RCP Dash Display no longer updating

Deleting the folder from AppData did it - thanks
PostForum: RaceCapture App Operation and General Q&A   Posted: Sun Feb 22, 2015 12:10 am   Subject: RCP Dash Display no longer updating

I am running RCP software on a Win 7, firmware 2.7.8. This morning I was playing around with some of the gauge config parameters and now none of the fields update on the dashboard screen that shows al ...
PostForum: Sensors   Posted: Mon Feb 09, 2015 5:23 pm   Subject: Tapping existing Tach line

Brent. Mine is a Mk2 with the latest firmware.
PostForum: Sensors   Posted: Mon Feb 02, 2015 2:59 pm   Subject: Tapping existing Tach line

Thanks for the info. As its protected I think my best bet might be to take the Tach signal directly from the 12v square wave off the MSD ignition controller. It worked with my old ChaseCam logger. I w ...
PostForum: RaceCapture/Pro introductions   Posted: Sat Jan 31, 2015 8:02 pm   Subject: Hi from NorCal LeMons racer

Hi guys. Just in the process of upgrading from ChaseCam setup to RCP for my CrapCan racer. Looking to get it all done for the March Sonoma race. Hope you see some of you up there.
PostForum: Sensors   Posted: Sat Jan 31, 2015 7:54 pm   Subject: Tapping existing Tach line

I'm new to this so bear with me. I have an MSD 6AL Ignition Controller and it outputs a tach line - delivers 12V square wave. Can I tap directly in to this for RPM on RCP or do I need some sort of res ...
 
Page 1 of 1
All times are GMT