RegisterSearchFAQMemberlistUsergroupsLog in
Search found 10 matches
Author Message
PostForum: Hardware and Installation   Posted: Fri Apr 28, 2017 2:27 pm   Subject: Proposed 1999 Miata Install - Please Check My Plan

Awesome, thanks Bryan. Any plans to wire up a wideband O2 like the Bosch lsu 4.9? I am trying to figure out if this sensor can be run directly to the RCP3 or if you still need a controller.
PostForum: Hardware and Installation   Posted: Thu Apr 27, 2017 10:45 pm   Subject: Proposed 1999 Miata Install - Please Check My Plan

Thanks for the update.

so you plan is to use the stock miata sensors on the car already? Do you have a plan as far needing a pull up resistor in line or who the calibration might go? The miata oil ...
PostForum: Hardware and Installation   Posted: Fri Apr 14, 2017 4:41 pm   Subject: Proposed 1999 Miata Install - Please Check My Plan

How did this install go? I am very interested in the Tach setup because I am about to do it on my 1990 Miata. Did you need any kind of resistor for the tach signal? What did you need to do in order to ...
PostForum: Sensors   Posted: Wed Apr 12, 2017 4:45 pm   Subject: Miata Oil Pressure Set up

It's difficult to know because I don't have anything to compare it to. But typically there is little to no lag between when I hit the throttle and when the oil pressure increases.
PostForum: Sensors   Posted: Tue Apr 11, 2017 11:11 pm   Subject: Miata Oil Pressure Set up

So I was curious if anyone has tried to hook up the oem Miata oil pressure gauge to the RCP. I found the resistance values the corrispond to pressures. My guess is that this style gauge will not work ...
PostForum: Sensors   Posted: Tue Apr 11, 2017 10:25 pm   Subject: Miata Fuel Gauge set up

awesome, thanks for the clarification.
PostForum: Sensors   Posted: Tue Apr 11, 2017 9:57 pm   Subject: Miata Fuel Gauge set up

So basically just pull from the leads that are going into the back gauge cluster?
PostForum: Sensors   Posted: Tue Apr 11, 2017 1:17 pm   Subject: Brake pressure

What size pressure gauge would need to be installed? I have no idea what kind of pressure to expect from say a Miata brake master cylinder.
PostForum: Sensors   Posted: Tue Apr 11, 2017 1:13 pm   Subject: Miata Fuel Gauge set up

Well it took some time but I figured how to get it to work. I had the right settings, it was the dashboard Fuel Level gauge that required to be removed and re-installed. I was getting the readings in ...
PostForum: RaceCapture/Track Operation   Posted: Mon Apr 10, 2017 6:39 pm   Subject: RC to pre-OBD II

I am also wondering the same thing for a few of the gauges.

I talked to Brent about this topic, there is no plug and play method to get the OBD1 ECU to work directly with RCP. You will need to get ...
 
Page 1 of 1
All times are GMT