RegisterSearchFAQMemberlistUsergroupsLog in
Search found 9 matches
Author Message
PostForum: Ignition Map Library   Posted: Sun May 12, 2019 12:36 pm   Subject: Chevy 2.2 4cly

I have a Chevy s-10 1996 inline 4cly 2.2L... wasted spark. Does anyone have a map for this ?

THANKS IN ADVANCE!
PostForum: Installation   Posted: Fri Apr 27, 2018 1:36 am   Subject: need pinout for Megajolt E1

The molex connector on my MJ E was removed and lost ! Need Saw, pip 12v+ and Neg. The vehicle install guide only shows Pip & saw going to MJLjr and no pinout. It used to be here and I have used ...
PostForum: Installation   Posted: Tue Nov 26, 2013 7:15 pm   Subject: tests for the 4-edis module

Thanks again. BMC

But I really want to know the signal should be like. So I can drag out the O-scope and test the EDIS module.


Anyone ??
PostForum: Installation   Posted: Mon Nov 25, 2013 6:24 am   Subject: tests for the 4-edis module

bmc,

I don't have a wire hooked up to pin #2 on the EDIS...

And if your speaking of the coil, pin #2 is 12v+ pin1 is 1&4cly coil.. and pin3 is 2&3cly coil..

I have a bare minimum ins ...
PostForum: Installation   Posted: Mon Nov 25, 2013 3:22 am   Subject: tests for the 4-edis module

well what is the EDIS voltage or signal at the pin numbers 10 & 12?

is it a 12v+ that stays at 12v+ until it goes Neg and fires the coil.. or is it a 5v+ that rises to 12v+ and fires the coil.. ...
PostForum: Operation   Posted: Sat Nov 23, 2013 8:48 pm   Subject: Delay spark after set number of revs

yep tried that first....
PostForum: Installation   Posted: Sat Nov 23, 2013 8:02 pm   Subject: tests for the 4-edis module

Looking for some info on the signals I should see at the coil output...a and b.. at cranking.. is it a Neg pulse to fire the coils?

I know this is a dumb question, but My install was up and runni ...
PostForum: Future Upgrades   Posted: Sat Nov 23, 2013 6:05 pm   Subject: START DELAY TILL' SPEC RPM

My MJjr has only one issue,, it fires instantly.. kicking back against the starter... Even before the engine has made 1 full rev the coil has fired!!

My suggestion: A set number of rev's before MJj ...
PostForum: Operation   Posted: Tue Sep 03, 2013 4:02 am   Subject: Delay spark after set number of revs

I have a Megajolt/e and love it ... but when I start my 4cly , it fires on the first rev ( or even part of a rev ) and kicks back against the starter.. HARD,, I would like to delay the spark for a few ...
 
Page 1 of 1
All times are GMT