Autosport Labs

Please see picture. I want to wire the 12v from the same circuit. Is this how you do it? Also what do I do with the coil power wiring from Megajolt. Pin 1. Shall I just leave that? And what about the shield connections for VR cable and PIP/SAW. Do I have to ground these at Pin 9? I have gone to all ...

bmcdaniel wrote:You'll be fine without holes. Mine even has carpet covering half of the module.

Thanks. I can now start preparing wires.

I have the EDIS and Megajolt sitting next to each other inside on the passenger side firewall. Makes for a short PIP / SAW cable and easy to ground the units together. Does firewall have any openings to allow air pass through? As glove compartment does not. When drilling the hole through to get cab...

Can I have both megajolt and edis module in the glove compartment? I find it will be easier for me to get the wires through into the engine bay this way as there's a rubber grommet ready to be poked out in the engine bay.

Thanks

My first post. Been reading up on the net. Time to iron out a few more questions. Help very much appreciated. 1) See attachment. I want to use electrical connectors like this to make it all clean installation. But these connectors are rated 14 amp. Can I use this connector on all types of gauge wires?