Load Bins V3.1.0

Report problems on the Megajolt firmware and PC software

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
SRandle
Posts: 3
Joined: Wed Oct 27, 2004 3:40 pm
Location: Rugby England
Contact:

Load Bins V3.1.0

Post by SRandle »

New software looking good. All seems to work OK.

One question about load bins.

After performing the TPS calibration noticed the load bins remain the same. Is this correct?

Steve.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Correct. *you* define the

Post by brentp »

Correct. *you* define the load bins- with the new TPS calibration, the load should accurately indicate 0-100%, so you need to make your load bins correspond to that range by hand. It's a one-time conversion on your part, of course.

Brent
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

SRandle
Posts: 3
Joined: Wed Oct 27, 2004 3:40 pm
Location: Rugby England
Contact:

Calc load bins

Post by SRandle »

Hi Brent

Thanks for quick repley, does that mean the load bins are now 10, 20, 30...90, 100. or am I thinking in the wrong direction.

Steve.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

They have to increase from

Post by brentp »

They have to increase from top to bottom, but they don't have to be in multiples of 10.. they can be 10, 15, 20, 37, etc.

Also be sure check out the 3D tuning screen- you can adjust the load and RPM bins by using ALT combined with the arrow keys.

Brent
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

SRandle
Posts: 3
Joined: Wed Oct 27, 2004 3:40 pm
Location: Rugby England
Contact:

Bin values

Post by SRandle »

Brent

Does that mean the values are in the range of 0-100. as at pressent they go to about 160 from old config.

Steve

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

yes- your load bin values

Post by brentp »

yes- your load bin values should range from 0 - 100.
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

SRandle
Posts: 3
Joined: Wed Oct 27, 2004 3:40 pm
Location: Rugby England
Contact:

Thanks

Post by SRandle »

Hi Brent

Have reloaded bins etc ok. All is sounding good on tickover.

Will report back later in week as to how car runs.

Thanks again

Steve

SRandle
Posts: 3
Joined: Wed Oct 27, 2004 3:40 pm
Location: Rugby England
Contact:

Running OK

Post by SRandle »

Just to fill you in on latest developments

Car was run on rollers for first time as part of a group outing for our tiger owners club.

Car ran ok up to 5000rpm then power was down. appears our map was not too good after this so more work needed.

Thanks again for your support,

Steve.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Thanks for the progress update! I encourage you to share your Ignition configuration in the new Ignition map library when you feel that it's done.

Post Reply