Current Ignition Configuration in MJLJ Config is Incorrect?

Report problems on the Megajolt firmware and PC software

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
jestes
Posts: 43
Joined: Fri Jan 18, 2013 2:54 am
Location: Spokane, WA
Contact:

Current Ignition Configuration in MJLJ Config is Incorrect?

Post by jestes »

Based on the protocol spec, bit 7 of byte 6 in command 0x53 indicates the current ignition configuration. Set = Config 1 Cleared = Config 2. The MJLJ Configurator appears to display it backwards in the status bar.

Post Reply