Need step by step instructions

General discussion on Autosport Labs, the mission, website, content, etc.

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
herbertgomez
Posts: 4
Joined: Wed Dec 06, 2017 10:00 pm

Need step by step instructions

Post by herbertgomez »

I have tried, to the best of my knowledge, everything to make race capture communicate with my S300. I have been unsuccessful.
Need help. I can see the S300 in my laptop; I can see race capture communicating , standalone, with the tablet.
However, we can not make race capture communicate with Hondata.
Pretty sure is a set up problem but need more knowledge and help as well but in a step by step form.
Do you have any kind of Telemetry system that can work with Hondata S300?

Canyonfive
Posts: 69
Joined: Mon Jan 29, 2018 11:20 pm

Re: Need step by step instructions

Post by Canyonfive »

Sure.

1) Do you have the canbus hooked up from the RCP to the s300?

2) https://www.hondata.com/help/smanager/i ... output.htm

As seen here the s300 does not have a termination resistor. You'll need one of those if you want it to communicate.

3) Post your RCP file so we can see what you did and help you.

herbertgomez
Posts: 4
Joined: Wed Dec 06, 2017 10:00 pm

Re: Need step by step instructions

Post by herbertgomez »

Thanks.
Yes, S300 Can H is hooked to RCP CanH1 and S300 CanL is hooked up to RCP Can L1.
Between both Can cables, we put a 120ohms resistor

How do I get/retreive the RCP file?

You can call me if you want- 305-336-6881

Also, RCP has instructions for RPM for our Bseries engines ECU that says to go via Pulse.
Do you have any kind of Telemetry system that can work with Hondata S300?

Canyonfive
Posts: 69
Joined: Mon Jan 29, 2018 11:20 pm

Re: Need step by step instructions

Post by Canyonfive »

Go to settings in your app > Then save > Go to the file explorer in your device and search for the name. > Email it to yourself, then you can post it here.

herbertgomez
Posts: 4
Joined: Wed Dec 06, 2017 10:00 pm

Re: Need step by step instructions

Post by herbertgomez »

Is this step is to install race capture in the tablet?
If so, its already installed .
Do you have any kind of Telemetry system that can work with Hondata S300?

Canyonfive
Posts: 69
Joined: Mon Jan 29, 2018 11:20 pm

Re: Need step by step instructions

Post by Canyonfive »

no its so me or anyone else can load your settings rather than have you post them. Its easier... Or you can post all your canbus settings and details.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Re: Need step by step instructions

Post by brentp »

The step-by-step instructions for Hondata is here:
https://wiki.autosportlabs.com/Hondata_KPro4

the general setup instructions are on the wiki http://wiki.autosportlabs.com.

Post Reply