Superchargerd Rover V8

Browse and share Ignition Configurations in this forum

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
steven 90
Posts: 1
Joined: Fri Jun 16, 2017 4:22 pm

Superchargerd Rover V8

Post by steven 90 »

I have fitted a eaton m 90 with lpg on my rover V8 ( no gasoline)

Now i am looking for a ignition map, at first it started after a lot of starting and revd verry hard, found that there was a vacuum leak. Fixxed it and did not run since then


Now even with megajolt disconnected, it will not even start up, a bitt of backfire, not running annymore.

I have tried the standard map on the cd rom, and with vacuum advance disconnected, no luck.

Should i take vacuum advance from the suction off the blower ore use the pressure side ?

I have sett the megajolt to pressure and with the needle saying 100 kpa this is atmopsheric pressure ? So iff the needle go's tot lets say 30 this is more vacuum ?




:?

Post Reply