Internal assembly wire gauge?

Discussion on the Hard Rev Limiter module, currently under beta testing. <a href="">Project Information</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Posts: 2
Joined: Sun Feb 14, 2010 6:19 pm

Internal assembly wire gauge?

Post by Mongo »

Brent, I just finished the assembly of the Hard Rev Limiter and have a concern.
when installing the assembly into the MJ the instructions say to use a 14ga. wire for the +12v and the coil wire. I found that the holes were not large enough for 14ga. wire. The largest wire I could fit without trimming off conductors was 18ga.
What are your suggestions?

John DeHaan

Post Reply