Brent, I just finished the assembly of the Hard Rev Limiter and have a concern.
when installing the assembly into the MJ the instructions say to use a 14ga. wire for the +12v and the coil wire. I found that the holes were not large enough for 14ga. wire. The largest wire I could fit without trimming off conductors was 18ga.
What are your suggestions?
Discussion on the Hard Rev Limiter module, currently under beta testing. <a href="http://www.autosportlabs.net/Hard_rev_limiter_1.1.0">Project Information</a>
1 post • Page 1 of 1