Hi,
was wondering if would be any possible to share the map sensor signal from the MS board, I don't mind running extra wire from my MS board.
Map sensor
Moderators: JeffC, rdoherty, stieg, brentp
something else I'm wondering
If I get pin #1 from MS board and run a wire to pin #1 of MJlite JR, but wondering if it could have a impact on input signal.
Else could I use external map sensor and generate a inc file?
Math
Else could I use external map sensor and generate a inc file?
Math
It sounds like it may be poss
It sounds like it may be possible, but.. it's only $18 extra! 
Here's how I hooked mine up with two map sensors. Note this was the V1 controller..
<img src="http://picasso.org/misc/mr2/engine_mana ... loseup.jpg">
Here's how I hooked mine up with two map sensors. Note this was the V1 controller..
<img src="http://picasso.org/misc/mr2/engine_mana ... loseup.jpg">
