New Podium Connect - Firmware update failed

Race Capture Pro hardware installation- power, wiring, physical installation, etc. See the dedicated forum for Sensor related topics

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Posts: 1
Joined: Sat Feb 20, 2021 3:13 pm

New Podium Connect - Firmware update failed

Post by nickshanny »

Hi there,

This is my third podium connect. I was trying to install the latest firmware and now the podium connect is stuck with a blinking SD Card Light. It was powered correctly and the update was progressing fine, but then failed while transfering the firmware. I am hoping that it is stuck in bootloader mode. Any ideas?

Nick Shanny

Site Admin
Posts: 6233
Joined: Wed Jan 24, 2007 6:36 am

Re: New Podium Connect - Firmware update failed

Post by brentp »

Sounds like a failed firmware update. Simply perform the firmware update again; you will need to load a previously saved racecapture configuration in the setup view, then you will be able to access the firmware update page.
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply