how can i simulate a waveform

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
eds911915
Posts: 32
Joined: Wed Mar 14, 2012 1:51 am
Location: Costa Mesa CA. USA

how can i simulate a waveform

Post by eds911915 »

could anyone tell me what is the easiest/cheepist way to send a 36-1 vr signal into a EDIS-4 module pins 5&6. i wanna trick the system. iv seen the megasquirt stimulator but i dont fully understand how it works.

brentp
Site Admin
Posts: 5986
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

There is a way to play back a .wav or .mp3 file that simulates the correct signal- the speaker output of the computer would connect to the VR sensor input of the EDIS module. Note, we have not tested this directly, but other users have reported success.

Also: you can make a test bench with a motor / drill and a 36-1 wheel- perhaps using a gear or sprocket. This will be the most realistic way of simulating short of of a spinning crankshaft.
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply