No RPM

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
adsblacksud
Posts: 1
Joined: Sun Aug 02, 2015 8:14 am

No RPM

Post by adsblacksud »

Hello
I have installed a very early (v 2.0.1) unit to my Alfa boxer engine
Currently there is no RPM signal showing on the configurator
I have MAP showing, sparks at the plugs and have tried alternative crank sensor, Edis and coil packs to no avail
The PIP and SAW are definitely wired the correct way around and there is 12v to around 4.5v on cranking
The only thing that is incorrect about the install is that the crank sensor lead is not shielded along its entire length as it needed to be extended.
Could this be it?
Thanks
Adam

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi,

Apologies for the late reply.

You should verify voltages for the EDIS system as well as the voltages going to and from the Megajolt. This is a handy reference chart:
http://autosportlabs.net/MJLJ_V4_vehicl ... tion_Steps

Best results is if you use an oscilloscope to verify the signals.

If you verify voltages there may be an issue with the Megajolt system itself.

Please, let us know what you find out!
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply