MJLJ v3 Firmware update - Can't read MCU info.

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
johnniem57
Posts: 1
Joined: Sun Nov 20, 2005 2:29 pm

MJLJ v3 Firmware update - Can't read MCU info.

Post by johnniem57 »

Hello, I was trying to change my firmware from V3.0.0 to V3.3.1.
On turning the ignition on the message came up in the screen shot attached:
received 0xc0 (off-key).
Can't read MCU info. Could be protocol error.
(or forgot to set single wire mode?)

What is single wire mode? What does it mean by protocol error? What do I need to do to fix this? please make the explanation pretty basic as this is not an area I have any expertness in.

It was working fine before I did this, I haven't tried it since, I'm assuming it failed to make any changes.

John
Attachments
Screen shot
Screen shot
MJLJ FIRMWARE SCREENSHOT.jpg (200.05 KiB) Viewed 3568 times

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

On that older hardware, try using a real serial cable, if possible, or try a different USB adapter.

Does the original firmware still operate otherwise?
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply