I was a bit shocked as I tried my first setup that the maximum rate of calculations is only 30Hz.
This does not make sense to me at all and is a massive blocking point. I´mean why to have high-speed CAN interface and high-speed analogue inputs and then limit the possibilities to read these value to only 30Hz?
Is there a way to gain this? Perhaps directly in the firmware?
Discussion on the Lua Scripting capabilities for RaceCapture/Pro. Also see the <a href="http://autosportlabs.net/RaceCapturePro_Lua_Scripting">Lua Scripting Guide</a>
3 posts • Page 1 of 1