Page 1 of 1
RCP Mk1 advice
Posted: Thu Jun 04, 2015 3:13 am
Which version of the firmware and software is recommended for Mk1 RCP? I sent my unit back to Autosport Labs and it was updated to the latest firmware I believe. I connected with the latest software and it appears to recognize the unit (I don't get a message that it isn't found and there are blue and green icons in the upper right). I can't tell if the RCP is actually recording GPS or acceleration from the software interface. I also don't seem to be able to configure anything including the Real Time unit. Should I be using older software and firmware? The 'Analysis' part doesn't seem to do anything in this version.
Re: RCP Mk1 advice
Posted: Fri Jun 05, 2015 1:00 am
drKorf wrote: The 'Analysis' part doesn't seem to do anything in this version.
Yeah, I noticed that, and that alone might cause me to revert back to the RaceAnalyzer software since I'm not running "telemetry" and don't care about "cloud" analysis. So I'm hoping the RaceCapture app supports the "offline" analysis soon!
Posted: Sun Jun 07, 2015 12:48 am
I finally got everything configured properly. I was able to 'see' my car in the driveway from the website. I'm using the Mk1 with the latest V2 firmware and software. Can't wait to try it at Willow Springs next week in the Lucky Dog race.
Posted: Tue Jun 09, 2015 8:52 pm
Hi folks, we recommend using the latest firmware and app to configure your RCP (Mk1 or Mk2). You can still use Raceanalyzer to review your log data until we have analysis in the new app.
Posted: Wed Jun 10, 2015 1:38 pm
where can I get a copy of raceanalyzer?
Posted: Wed Jun 10, 2015 2:25 pm
Posted: Wed Jun 10, 2015 8:29 pm
looks like raceanayzer is not compatible with a mk1 racecapture running v2 firmware....