Haltech 1500 to Mk3

Discussions on CAN mapping for ECUs, sensors, PDMs, and more.
Post Reply
Aussieotto
Posts: 4
Joined: Sun Mar 17, 2019 4:02 am

Haltech 1500 to Mk3

Post by Aussieotto »

folks

I have a Mk3 and a Haltech 1300

I have the Haltech harness and I have connected

Haltech Mk3
Blue Can 2 high to Can 2 high
Blue/whit to Can 2 low
Orange white to And

12 v not connected

When I run the script to see if any data . nothin ( scripts been changed to use can )

Stop one can anyone confirm pinouts for Haltech elite to a Mk3 ?

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Did you figure this out yet? You may want to double check:

* CAN high / CAN low wiring
* Termination is enabled on both ends (RCP MK3 is software controlled, under setup)
* Baud rate is identical on both ends
* CAN output is enabled with the Haltech

We have a generic CAN bus logger that will show if anything is being read from the CAN bus:
https://wiki.autosportlabs.com/CAN_Bus_logger

Hope this helps, please let us know what you find out:
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply