Dual Can hub, no connectivity to pro3

Discussions on CAN mapping for ECUs, sensors, PDMs, and more.
Post Reply
Posts: 2
Joined: Mon Jun 14, 2021 4:54 am

Dual Can hub, no connectivity to pro3

Post by Swiftman_23 »

I have a pro3, using rj45 to can adapter with dual can hub, analog x2, 4 sensor splitter with plug and play system. Pro3 connected to raspberry pi. Rpm gauge works great, but cannot get can bus to connect.

I have gone through the setup protocols listed meticulously 4 times. I am getting clean 12v on my can power, however my pro3 will not flash led indicating connectivity to can bus. any ideas? Thank you in advance

Site Admin
Posts: 6233
Joined: Wed Jan 24, 2007 6:36 am

Re: Dual Can hub, no connectivity to pro3

Post by brentp »

Hi, You will need to set the baud rate for CAN 2 to 1 MB, not the default 500K you might have. AnalogX2 is 1MB by default.

Please let us know what you've found out after testing that.

Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply