Autosport Labs

I have a pro3, using rj45 to can adapter with dual can hub, analog x2, 4 sensor splitter with plug and play system. Pro3 connected to raspberry pi. Rpm gauge works great, but cannot get can bus to connect.

I have gone through the setup protocols listed meticulously 4 times. I am getting clean 12v on my can power, however my pro3 will not flash led indicating connectivity to can bus. any ideas? Thank you in advance

Hi, You will need to set the baud rate for CAN 2 to 1 MB, not the default 500K you might have. AnalogX2 is 1MB by default.

Please let us know what you've found out after testing that.

Thanks,