Prepare other CAN ID?

Q&A for AnalogX Analog to CAN interface. <a href="https://wiki.autosportlabs.com/AnalogX">Installation and Operation Guide</a>
Post Reply
Takabayashi
Posts: 21
Joined: Tue Nov 13, 2018 5:23 am

Prepare other CAN ID?

Post by Takabayashi »

If set some AnalogX, can i use other ID &#65311;
My understanding is only prepare 0xE4612.
i want to use 2 or 3 AnalogX.
i mean need 8&#12316;12 channel.

Takabayashi
Posts: 21
Joined: Tue Nov 13, 2018 5:23 am

Gentle remainder

Post by Takabayashi »

Hello ,
i saw similar issue past subject.
But i could not see answer.
Could U tell me something idea?

ferg
Posts: 36
Joined: Mon Dec 03, 2018 7:56 pm
Location: Paso Robles, California
Contact:

Post by ferg »

You can have up to 4 AnalogX on the same CAN bus. You just need to make sure each is set for a unique address.

For details on selecting the address see the section "CAN Base ID" on this page:

https://wiki.autosportlabs.com/AnalogX

Also note, the AnalogX has a CAN termination resistor across the CAN lines by default, you will likely need to remove some or all of these depending on your CAN bus. At most there should be two termination resistors on the CAN bus (one at each end of the bus is ideal).

Takabayashi
Posts: 21
Joined: Tue Nov 13, 2018 5:23 am

Post by Takabayashi »

Hello Ferg-san,

Thank you for your reply.

Need to cut the bridge each ADR?
How do i cut them?
Attachments
AnalogX_ADR.PNG
AnalogX_ADR.PNG (61.03 KiB) Viewed 3956 times

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi, we have a chart here that shows how to configure the base address, with instructions on how to cut.

https://wiki.autosportlabs.com/AnalogX#CAN_base_ID

Thank you,
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply