Canbus using 2 AnalogX's

Q&A for AnalogX Analog to CAN interface. <a href="https://wiki.autosportlabs.com/AnalogX">Installation and Operation Guide</a>
Post Reply
PS14
Posts: 97
Joined: Fri Feb 12, 2016 11:27 pm
Location: NY

Canbus using 2 AnalogX's

Post by PS14 »

Seasons over so im looking to clean up/simplify my wiring. I am looking to switch every sensor over to a canbus style harness. 8 linear sensors and two canbus AFR controllers. by using two AX's (one each end) and the AFR's/MK2 in the middle. would this work properly as far as canbus termination. see attachment for a sketch. thanks Dave.
Attachments
CANBUS.pdf
(203.74 KiB) Downloaded 224 times

ferg
Posts: 36
Joined: Mon Dec 03, 2018 7:56 pm
Location: Paso Robles, California
Contact:

Post by ferg »

AX1 & AX 2 should have CAN termination, all of the other CAN devices should not have termination.
David Ferguson
Veracity Racing Data
Autosport Labs Preferred Dealer
https://veracitydata.com

PS14
Posts: 97
Joined: Fri Feb 12, 2016 11:27 pm
Location: NY

Post by PS14 »

I believe the AX's are terminated by default, which is why I put one on both ends. the AFR's are not, so are you saying this schematic is correct? thanks for replying.

ferg
Posts: 36
Joined: Mon Dec 03, 2018 7:56 pm
Location: Paso Robles, California
Contact:

Post by ferg »

It seems like all the ASL devices have a the CAN bus terminated, and you cut a trace (or disable in software) the termination resistor. I was just responding that you should have termination at your two "end" devices, and none on any of the device in between. The lengths of your "branches" on the CAN bus should be 18" or less per the CAN bus spec, and the CAN Hi & CAN Lo Signals should be twisted together, about 1 twist per inch. Many CAN bus implementations don't meet all those specs and they work. But you can be sure things will work if you follow the spec.
David Ferguson
Veracity Racing Data
Autosport Labs Preferred Dealer
https://veracitydata.com

Post Reply