RPM problem

Information and announcements on updates to the Megajolt firmware and PC software

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
dainiux
Posts: 0
Joined: Wed Sep 21, 2005 6:45 pm

RPM problem

Post by dainiux »

HI all

The current software is working only on 4,6,8,12 CYLs. But what about 5 CYL (AUDI 100)?
If I turn on megaspark on 5 CYLs and set as it would be on 4 CYLs, then there will be showed even 1000 RPM instead of 800 RPM.
Could the 5 CYLs variant be expected?

Dainius

Oliver Sedlacek
Posts: 68
Joined: Mon Sep 13, 2004 8:45 am
Location: The Chalfonts
Contact:

EDIS 5

Post by Oliver Sedlacek »

The megajolt could be adapted easily enough, but you would need a 5 cylinder version of the EDIS coil driver. This would be a problem as the EDIS system is a wasted spark system, which always fires two sparks at the same time.

dainiux
Posts: 0
Joined: Wed Sep 21, 2005 6:45 pm

helloI will add logical

Post by dainiux »

hello

I will add logical elements and then outputs will be as needed.
But I am not programmer, so I cannot change software for 5 cyls. If software would work for 5 cyls, then it will show correct rpms and I will be able to change MAP correctly.


Dainius

mikerj
Posts: 0
Joined: Tue Nov 29, 2005 4:28 pm

Not suitable for 5 cylinder engines

Post by mikerj »

Megajolt is simply not suitable for 5 cylinder engines in it's current form (i.e. relying on the EDIS system).

Post Reply