RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
Internal assembly wire gauge?
Author Message
Reply with quote
Post Internal assembly wire gauge? 
Brent, I just finished the assembly of the Hard Rev Limiter and have a concern.
when installing the assembly into the MJ the instructions say to use a 14ga. wire for the +12v and the coil wire. I found that the holes were not large enough for 14ga. wire. The largest wire I could fit without trimming off conductors was 18ga.
What are your suggestions?

Thanks,
John DeHaan

View user's profile Send private message Send e-mail
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum