New Install, RPM Challanges

Post by **brentp** » Mon Apr 07, 2014 10:19 pm

Hi Rob, just to close out this thread, you were able to get RPM to work correctly? Thanks!

rob_h · Post by **rob_h** » Tue Apr 08, 2014 4:08 pm

Yep, used pin #9 off the OBD2 connector. Samples at 10MHz.

Post by **brentp** » Fri Jan 16, 2015 7:11 am

We have a MK1 2.7.7 pre-release firmware that appears to have fixed the RPM problems at RCP power-up. You can download it here:

http://dropcanvas.com/bthz0/30

If the link above is bad, you'll likely be able to download the official release in the regular downloads area.