Trigger wheel mounting vor V8

General Megajolt Questions and Answers

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Reggie
Posts: 1
Joined: Sun Jul 19, 2015 2:34 pm
Location: Wales UK
Contact:

Trigger wheel mounting vor V8

Post by Reggie »

Hello to everyone, i am new to this site registered today.

I am fitting a megajolt set up to a Westfield Seight i am using a Rover 4.0 L V8 i need confirmation that i am fitting the trigger wheel in the right position.
I have machined up a trigger wheel from a Ford Transit 36-1 am mounting it on the back of the pulley buy machining in a register on the back of the centre core of the pulley assembly. No problem with the machining i am a qualified engineer with a full workshop at home.

As i understand it for a V8 the trigger wheel gap(missing tooth) should be 50deg advance of TDC.
If anyone can confirm this before i bolt it in position and ballance it.

Thanks,
Reg

toenee
Posts: 75
Joined: Mon Aug 31, 2009 6:46 pm

Post by toenee »

If you look on this page theres a illustration that confirms 50 degrees for a V8.

http://www.autosportlabs.net/MJLJ_V4_ve ... stallation

Post Reply