Freescale MXP4250AP calibration

All sensor specific discussions! Temperature, pressure, steering angle, brake and throttle, etc. Post adaptations of OEM-style sensors, and also your clever DIY hacks and custom designs here too!

Moderators: JeffC, rdoherty, stieg

Post Reply
fmbo
Posts: 17
Joined: Sat Jul 11, 2015 2:59 pm

Freescale MXP4250AP calibration

Post by fmbo »

Hi everyone. Just wander if anyone have calibrated this sensor using a manometer? As the chart given in the documentation (http://prntscr.com/8d6wc1) doesn't allow to enter very accurate numbers.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi,

Check the datasheet on device; it has a linear response, which means you can define the sensor using a 2 point map.

http://www.freescale.com/files/sensors/ ... X4250A.pdf

20KPa = 0.5v ; 250 KPA is 4.75v.

When defining a 2 point map you can set the first two map columns and then fill the rest of the map with the same value as the 2nd column.

Let us know how it goes!
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply