Engine Temperature Sensor and Bias Resistor

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
E635815
Posts: 1
Joined: Wed Oct 12, 2016 6:32 pm

Engine Temperature Sensor and Bias Resistor

Post by E635815 »

I am about to wire a coolent temperature sensor on my RV8 to a Megajolt ECU.
It is a single wire probe design, therefore the ground will be done by the engine and chassis (I have upgraded the ground cables all around the car).
Now, in order to calibrate my sensor (AMR1425), I would like to tuse Easy-Therm to create the calibration table.
But for that, I need to know the value of the Bias Resistor on the Auxiliary Input channel.
Is there such a resistor (I guess yes) and what's its value (2.49k or 2.2k Ohms)?
Thanks for the answer.
Regards
Philippe

brentp
Site Admin
Posts: 6282
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi,

The pullup resistor is 2.2K ohms.

Thanks!
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply