OBDII Cable pinout.

General Q&A specific to RaceCapture/Pro. For app related questions post in the RaceCapture App forum. also see the <a href="http://www.autosportlabs.net/RaceCapture">RaceCapture Information Page</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
radixms
Posts: 11
Joined: Wed Mar 18, 2015 11:04 pm

OBDII Cable pinout.

Post by radixms »

I need the pin out diagram for the OBDII connector side of the OBD/RJ45 autosport cable.

Vehicle does not have OBD system, but will be using the CAN output from Hondata ECU to connect to RaceCapture MK2 OBD cable.

brentp
Site Admin
Posts: 6274
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi, the OBDII cable pinout conforms to the SAE standard OBDII pinout specifications. Note, only CAN, GND and power are connected. See the attached image.

For further reference, the RaceCapture RJ45 pinouts are here: https://wiki.autosportlabs.com/CAN_Bus_Integration

You can also take a CAT5 or CAT6 network cable and cut the end off as well, if you're hard-wiring a solution.

Hope this helps!
Attachments
OBDII port1070929671.jpg
OBDII port1070929671.jpg (90.77 KiB) Viewed 4669 times
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

radixms
Posts: 11
Joined: Wed Mar 18, 2015 11:04 pm

Post by radixms »

Thank you

Post Reply