RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
Converting from MAP to TPS
Author Message
Reply with quote
Post Converting from MAP to TPS 
I have a V3 board that currently works with MAP. I now have a set of bike carbs with a TPS attached, which may be the easiest option once I get them installed.

I should have no problem with adding the small number of extra components required for TPS, but I'd like to disconnect the MAP system with the minimum amount of disruption, in case I want to use it again later. Is there one component or link I could remove to isolate that part of the circuitry, so that it doesn't interfere with the rest?

cheers,
David

View user's profile Send private message Visit poster's website
Reply with quote
Post  
Removing R4 should do the trick.

Richard.

View user's profile Send private message
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum