[color=red]HELP PLEASE![/color]

FERNANDOF · Post by **FERNANDOF** » Tue Apr 08, 2008 3:03 am

SORRY FOR MY ENGLIS BUT I REALLY NEEDS HELP!

Im new with megajolt, i bought my megajolt v3 and im assembling my kit but i don't know what is next
do i need to load the firmware before use it?? or my megajolt have preloaded firmware? should it work if a don't load the firmware??

Post by **brentp** » Tue Apr 08, 2008 4:30 am

Greetings,

Yes, the firmware is already installed on your processor, you do not need to load it.

Here are the basic steps:

1. Assemble the kit
2. Install Megajolt and EDIS onto your vehicle
3. Install PC software, test, configure, and tune your ignition system.

All of the documentation is under the 'how to' section of the website, link at the top.

Kit assembly and electrical testing:
http://www.autosportlabs.net/MJLJ_V3_kit_assembly_guide

Engine installation:
http://www.autosportlabs.net/MJLJ_V3_ve ... tion_guide

Software installation and operation.
http://www.autosportlabs.net/MJLJ_V3_Operation_Guide

We hope this helps. Let us know if we can help further!

FERNANDOF · Post by **FERNANDOF** » Tue Apr 08, 2008 5:22 am

Tanks mr. brentp!!

and i have one more question, i want to knok if my precessor have the Dual on-the-fly switchable Ignition ready

Post by **brentp** » Tue Apr 08, 2008 5:51 am

If you purchased your kit recently, then yes- the firmware has this feature.

You will need to enable it- the instructions on how to do this is in the 'Operation Guide'.

Regards,