What does MJLJ do between rpm sites?

KITT · Post by **KITT** » Fri Sep 03, 2004 10:47 am

What does MJLJ set the advance to be between rpm/MAP sites?

e.g. if you set the rpm sites to be every 500rpm what does it set the advance to be at say 2300rpm? Does it pick the nearest site (in this case 2500rpm) or does is average the difference between the 2000rpm and 2500rpm sites?

Josh_b · Post by **Josh_b** » Fri Sep 03, 2004 8:55 pm

would stay at 2000 until the 2500 site was reached, if i understand it correctly

Oliver Sedlacek · Post by **Oliver Sedlacek** » Tue Sep 14, 2004 12:33 pm

It just uses the lower RPM bin value. Interpolation between sites is one of the requested enhancements

Post by **brentp** » Tue Sep 14, 2004 4:10 pm

that's correct.

Interpolation will be in the firmware next release, plus a few other goodies.

Brent

KITT · Post by **KITT** » Wed Sep 15, 2004 10:27 am

Sounds good Brent! I've just started soldering my MJLJ together and have 5v at all the correct places

) Will continue tonight.

Just need to find a toothed wheel now.......

Autosport Labs

What does MJLJ do between rpm sites?

What does MJLJ do between rpm sites?

it

It just uses the lower RPM bi

that's correct. Interpolat

Keep up the good work!