Hey wolfe83,
I'm not sure but assume that your assumption is probably wrong...
wolfe83 wrote:
Podium is physically connected to the system through an AIM 4 port data hub, which is connected to the AIM MXG in the car. I assumed that allows Podium to get CAN messages from both the AIM and AEM, since they talk to each other. Let me know if that's a flawed assumption.
Where did you plugged the data hub on the MXG?
And what else is connected to the datahub?
In case you didn't repurposed the datahab for your own wiring but rather plugged it straight to the MXG expansion connector as it is meant to be, then you will hardly receive AEM CAN messages...
The AEM ecu CAN wires are most likely connected to CAN1 of the MXG, which is independent from the proprietary AIM expansion CAN where the SmartyCam and similar AIM devices are meant to be connected.
So please confirm where are the AEM CAN wires going to and/or where did you connected the datahub, which you use for PodiumConnect.
Otherwise please post the AIM config and the PodiumConnect config (I'm talking about the files and not a screenshot) to go from there.
Regards, Mike