No rpm despite PIP signal is ok

General Topics for configuring, operating and tuning the Megajolt. Also see the <a href="">Operation Guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Site Admin
Posts: 6281
Joined: Wed Jan 24, 2007 6:36 am

Re: No rpm despite PIP signal is ok

Post by brentp »

Can you confirm that you can read the load value (TPS or MAP sensor) in the software and you can read/write configuration - but no RPM signal?

Note, PIP signal to Megajolt is 5v, not 12v. You may have a mis-wiring on the EDIS plug. Try to double check the wiring against our installation guide.
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply