No 3D graphing when loading .cfg from previous version.

Pmoffatt · Post by **Pmoffatt** » Sat Dec 16, 2006 7:02 pm

God knows why, but the entire graph just disappears off the face of the earth, works fine if I start a new config though.

Post by **brentp** » Sat Dec 16, 2006 7:05 pm

I assume you're loading from a file? What do you see in the 2d editing grid? are the values normal (0-49 degrees)?

Brent

Pmoffatt · Post by **Pmoffatt** » Sat Dec 16, 2006 8:23 pm

Yep, all values appear good, it may be because I'm using TPS rather than MAP?

Config file is here: http://www.box.net/public/lt8auk8h61

Pmoffatt · Post by **Pmoffatt** » Sat Dec 16, 2006 9:05 pm

Ok, sorted it, it didn't like my preference for having the maps the other way up, doh.

New config, tweaked values, if of any use to anyone (vw aircooled on dellorto 40's, 1.8 litre from 1.6, fast road cam + heads, 4-1 exhaust): http://www.box.net/public/lt8auk8h61

And I spelt gauge wrong.

Is there any way to change the graph perspective?

Post by **brentp** » Sat Dec 16, 2006 9:05 pm

you mean you had the bins in reverse order? if that's the case then it won't be just the software not liking it; the controller will have problems as well.

so to confirm, rpm and load bins need to increase from load bin 0 to 9. the software should block you from doing this interactively, but invalid data may slip through on a file load. I guess not doing data validation on file load would be considered a bug.

Pmoffatt · Post by **Pmoffatt** » Sat Dec 16, 2006 9:30 pm

Worked fine on the car

Autosport Labs

No 3D graphing when loading .cfg from previous version.

No 3D graphing when loading .cfg from previous version.

I assume you're loading from

Yep, all values appear good,

Ok, sorted it, it didn't

you mean you had the bins in

Worked fine on the car ;)