RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
no advance control
Author Message
Reply with quote
Post no advance control 
Hello all, I have been running megajolt now for 5 years on my aircooled VW and it has worked flawlessly however I now have an issue,

About a week ago I started the car noticed it was running poorly so I hooked up the laptop and saw that I was not getting a RPM signal (TPS was working fine) and my timing was locked at 10 degrees both in the configuration window and verified with a timing light. So I checked the wiring and all seems fine then I checked the VR sensor and with engine cranking I'm getting 1-1.5v AC at the EDIS module and with the engine running I get 6-6.5v DC at the megajolt module , not being sure if that could be the problem I decided to check through the configuration settings and although I did not change anything prior to the issue in my engine parameters my number of cylinders had changed from 4 to 10, cranking advance changed from 5 to 76 and filter level was also at 70 something. So I reset the parameters and now its getting an RPM signal but although its showing in my timing configuration window that the timing is advancing as it should (both with and without the TPS hooked up) when I went to verify with a timing light its still showing that I am locked at 10 degrees at the engine.

Could this be an indicator of a bad EDIS module? Any help would be greatly appreciated.

Thank you

View user's profile Send private message
Reply with quote
Is the voltage going into the unit at least 12v?
If not, I'd be looking at the alternator.


View user's profile Send private message Visit poster's website
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum