RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
MPA pressure sensor calibration
Author Message
Reply with quote
Post MPA pressure sensor calibration 
I want to set up the pressure sensor so that it has the same characteristics as the OEM stock vacuum advance module.
To do this I would like to know the actual pressures associated with each bin so I can match the advance to the vacuum value.
Even better, can one set the pressure in each bin and then input the desired advance?

I am confused by the illustrations showing gauge readings up to 255 kPa which is far in excess of typical maximum vacuum of about 60 kPa

I have ordered a Megajolt and it should be here in a few days so I can't do any practical work just yet - just thinking ahead.

Thanks
Bruce M
Jaguar Mk2

View user's profile Send private message
Reply with quote
Post  
Further to my last post, I now realize that the pressure sensor reads absolute pressure.
Anyway I would still like to know the mapping of teh pressure to teh bins
Bruce

View user's profile Send private message
Reply with quote
Post  
OK I think I have it now.
I can edit the load bins to get the pressures I want

Bruce

View user's profile Send private message
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum