RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
Mini 1275
Author Message
Reply with quote
Post Mini 1275 
Mini, A+ engine, 1275ccm, normally aspirated, 35,7/29mm valves, ported head, Kent MD286 cam, MAP sensor



Last edited by KLAS on Thu Apr 12, 2007 8:17 am; edited 2 times in total



MiniSPi2-MD286.mjlj
 Description:

Download
 Filename:  MiniSPi2-MD286.mjlj
 Filesize:  714 Bytes
 Downloaded:  2009 Time(s)

View user's profile Send private message
Reply with quote
Post  
Klas,

Tried to download thsis map just to see what it's like, not up & running yet but it fails to load I get the following error.

Failed to load Ignition Configuration

Could not read configuration file: Malformed data on line 0 (MJLJ)

Might be me, but the file might be corrupted.

Alan...

View user's profile Send private message
Reply with quote
Post  
thanks, you are right, changed the file
hope this one will work

View user's profile Send private message
Reply with quote
Post  
Yep, certainly does

OT does the Kent 286 have advantages over the standard MG Metro cam?

Alan...

View user's profile Send private message
Reply with quote
Post  
the MD286 cam revs from 2000-7500RPM and has a lumpy idle, i wouldn't use it again as my mini is daily driven. the MG Metro is a great cam, if you have one stick with it, gives good power.

View user's profile Send private message
Reply with quote
Post  
KLAS, I've borrowed this map to have a look at your settings, cheers. Wink

Hoping to get my 1380 running tonight. It's also on a 286cam, 1.5:1 roller rockers, vernier timing gear, but has a higher CR than standard (11:1) and will be running on UBER fuel with loads of additives. Also on 36mm inlets and 30mm exhausts, inhaling through a 45 DCOE and exhaling through a Maniflow phase 2 with large bore system.

I'll let you know how it goes Razz

EDIT: Wowzers, you've got some serious advance on there! Shocked

View user's profile Send private message Send e-mail MSN Messenger
Reply with quote
Post  
hope it helps you get it running

mafhoward wrote:
EDIT: Wowzers, you've got some serious advance on there! Shocked

yes, but it works, and i'm running 95 octane fuel with about 9.75:1 (i know it should be higher, next head will rise it, and 98 octane will be needed)
but listen for knock Exclamation

View user's profile Send private message
Reply with quote
Post  
i don't speak english, but try to understand me.

i have a A-series, 1380cc, 36mm inlets and 30mm exhausts, Swiftune 5, 11:1CR, 1.75SU, LCB, 1.5:1rockers

what config i used to this engine?, whit TPS.

please upload the config to load in the MJLJ for testing.

thank's

View user's profile Send private message
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum