MAP to TPS

Megajolt Kit assembly Question and Answers. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_kit_assembly_guide">Kit assembly guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
hillmanwings
Posts: 2
Joined: Mon Jul 14, 2014 2:48 am
Location: Australia

MAP to TPS

Post by hillmanwings »

Hi, I have a MAP optioned MJLJ, and I want to change to a TPS option. Can I simply solder in the additional components or do I have to remove the components for the MAP option?
Justin

toenee
Posts: 75
Joined: Mon Aug 31, 2009 6:46 pm

Post by toenee »

Yes the instructions are somewhere in here, you can get all the bits needed in the autosport labs shop. Not sure about leaving them in place, but I know you can't use both.

brentp
Site Admin
Posts: 6282
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

You can safely leave the components in place, just be sure to disconnect the TPS from the molex connector.
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

hillmanwings
Posts: 2
Joined: Mon Jul 14, 2014 2:48 am
Location: Australia

Post by hillmanwings »

Thanks for the reply. I have sorted this out. Removed the 270 ohm resistor from the MAP circuit and added the 7 components for the TPS circuit. Calibrated the TPS, works great.

brentp
Site Admin
Posts: 6282
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

fantastic. thanks for the update
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply